August 4, 2009

channel templates


After the Toile and denim front pieces were basted together it was time to start sewing channels.


First, I figured out the boning placement.


Then I made a template from the bottom of the horizontal stitching by tracing the patten onto a new piece of paper and running a tracing wheel across the line.


I cut the template out, taped it on the fabric, and started sewing.


Once I had that first line I could sew the rest using the presser foot as a guide.


Then I marked the center line with tape and sewed the vertical channels. I got the placement for the next couple of channels by placing the pattern on the fabric, pushing a pin through the starting point, 


lifting the pattern a bit and marking that spot with another pin. I did the same for the end point, then I marked the sewing line with tape.


I sewed down that line, then once down each side, and a few more channels were done. I have to insert boning into these channels before moving on to the next ones so I guess I'd better rustle up some boning.

No comments:

Post a Comment